Solar pumping, connected from day one.

Inselberg structures solar water-pumping solutions around the complete operating chain — solar generation, pump and controller, sensing, IoT communication, remote monitoring, installation and lifecycle support.

Discuss a Solar Pump Project Explore Remote Monitoring

Solar water pumping system with irrigation field and PV array

Reference Stack

Reference Solution Stack

Solar pump architecture.

A solar pump is not just a panel and a motor. The operating chain runs from PV generation through the controller, pump and sensors, then through IoT connectivity and cloud monitoring — before reaching the operations team.

Solar Pump Data Flow

PV ARRAY

→

PUMP CONTROLLER / DRIVE

→

PUMP + SENSORS

→

IoT / RMS + SIM

→

CLOUD

→

DASHBOARD

Optional grid input shown as dotted line only where hybrid design applies. Not locked to a particular motor/pump technology.

Components

Typical Components

Configured to site requirements.

The exact component mix depends on the water source, head, flow requirement and available solar resource — plus the level of remote visibility required.

Solar PV array
Surface or submersible pump
Pump controller / drive with protection
MPPT-capable control where applicable
Mounting structure and cabling
Protection and switching equipment
Water-level / flow sensing where required
IoT device / RMS gateway
M2M connectivity
Cloud / dashboard integration

Applications

Where solar pumping fits.

Four operating environments where solar pumping consistently reduces running cost and dependence on grid availability.

Agricultural irrigation field with drip and sprinkler applications

Agriculture & Irrigation

Borewell, canal, drip and sprinkler applications for farms and agricultural programmes.

Village and institutional water supply infrastructure

Community Water

Village, institutional and decentralised water-supply applications.

Remote Infrastructure

Water pumping in sites where reliable grid power is limited or operating cost must be reduced.

Hybrid solar and energy source installation

Hybrid Operations

Project-specific systems that combine available energy sources and control logic where technically appropriate.

Field service engineer working on a solar water pumping installation

Lifecycle Support

Operational Capability

Installation through lifecycle support.

From site commissioning through ongoing maintenance and remote visibility — the operational model is designed to keep the pump running and the reporting clear.

Installation and site commissioning
Connectivity activation and RMS onboarding
Pump run-status monitoring
Fault/alert visibility depending on controller capability
Remote start/stop where enabled and authorised
Preventive maintenance planning
Field service and breakdown coordination
Performance and service reporting

Safety & engineering note: Final pump sizing, electrical design, protection, water-source assessment and equipment selection must be based on site conditions and the approved engineering specification.